Looking for:
Autodesk inventor 2018 measure loop free
Angle Use one of the following methods: Select 2 lines, edges, or faces. Select 2 points, and then hold down SHIFT and select the third point of the angle. Select an arc or circle. Select a line or axis and then select a planar faces. Area and loop Select the contiguous, enclosed region to . On the ribbon, click Tools tab Measure panel Measure. Or, click Measure on the marking menu. In Inventor assemblies only, if desired, select a selection priority: Component, Part, or Edges and Faces. Select the Advanced Settings drop-down arrow and set . Tips for selecting edges and loops for contour flange. If necessary, click the right-pointing arrow for Distance, Angle, or Bend Radius to use Measure, Show Dimensions, or List Parameters to set values. The profile sketch must be coincident and perpendicular to one of the edges of the loop (not necessarily the edge used to select the loop).
Autodesk inventor 2018 measure loop free. To Create Patch, Stitch, or Ruled Surfaces
The Measure tool panel shows all possible values for your selections as well as the result from both selections. Ideally, we want to implement all of the good ideas.
What’s in Autodesk Inventor | Applied Software – One Measure Command
I just installed Trying to measure a loop length with no success other than adding it all up. I attached the part in question. Seems much more difficult and cumbersome now. Go to Solution. Solved by -niels-. With the measure command active, if i right-click on the line and choose “select other’ i can choose the loop i want to measure:. Measure the ID of the O-ring groove. What do you get? Not sire what loop the measurement is giving me unless I add them up. Inventor Forum. Share your knowledge, ask questions, and explore popular Inventor topics.
Turn on suggestions. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for. Search instead for. Did you mean:. This page has been translated for your convenience with an automatic translation service.
This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.
Back to Inventor Category. Back to Topic Listing Previous Next. Message 1 of Hi all, I just installed It is an O-ring groove I. Message 2 of Message 3 of Message 4 of Message 5 of Ok, other side inner loop: does it match your measurement? Message 6 of Message 7 of Message 8 of Select one of the lines and roll mouse wheel until you get the loop. John Retzlaff. Message 9 of Am i right in assuming the mouse wheel is just a shortcut to the “select other” function?
Message 10 of Message 11 of Select line and roll wheel mouse. I like it. I had to let it pause a second or else it would give me the linear dimension. Good tip.
Post Reply. Can’t find what you’re looking for? Ask the community or share your knowledge.